Constant temperature heating table products are mainly used in:

Class: LED lamp category: including LED aluminum substrate welding constant temperature heating table, LED bead soldering table, LED bead repair table, LED heating platform, LED repair heating table, etc.

The second category: LCD/LCD maintenance heating table category: including constant temperature heating table, LCD equipment, LCD maintenance, LCD maintenance, mobile phone LCD maintenance equipment, dismantling and arranging wiring, etc.

The third category: laboratory heating table: biochemical test heating table, biochemical laboratory preheating board, experimental radio heating table, laboratory heating equipment, laboratory heating furnace, laboratory digital temperature control heating table - constant temperature heating table, is an essential tool for biological, genetic, medical and health, environmental protection, biochemical laboratory, analysis room, teaching and research.

Fourth category: electronic component heating platform: electronic component heating platform, hardware preheating platform, component heating platform, preheating platform.

Use method of constant temperature heating table:

1. Turn on the power supply and turn on the "power switch" when the green "power indicator" is always on, indicating that the equipment has been powered.

2. Turn on the "warming switch" equipment and start running. The red "warming indicator" is always on, indicating that the surface worktable is continuously warming up. The flicker indicates that it is in a constant temperature state. At this time, the surface worktable of the thermostatic heating platform manufacturer is intermittently warming up.

3. After use, turn off the "warming switch" and the warming part of the equipment stops running. At this time, the green "power indicator" is still on, which can indirectly warn the equipment is still working. Do not touch the working panel. Turn off the "power switch" after the surface panel is completely cooled (1 hour is recommended).

There are basically six points to note

1. The power supply voltage is 220 VAC, and there must be three-hole socket of grounding wire and leakage switch.

2. Non-professionals should not open the chassis or change the internal wiring without authorization.

3. Do not touch the heating plate directly with your hands to avoid scalding.

4. When you are not using or going out for a long time, please cut off the power supply.

5. This equipment has air-cooled heat dissipation device. Do not block the side air inlet of the equipment.

6. When replacing the safety pipe, please unplug the power plug before replacing it, so as to avoid the danger of electric shock.

However, it is usually used at the beginning of plate lighting. The heating platform is www.fanyuhang.com.

In large quantities, you are advised to machine the patches outside.

After all, much of the paste manually applied on the welding platform is not as good as that on the machine.

If there is too much solder paste, it will affect the patch lamp beads, and even more serious, the lamp will die.