Welcome to the official website of Chuanghui Electric Heater in Yancheng!
盐城市创惠电热科技有限公司
张天:15895191047
杜文华:13961983587
许中勇:13962067633
邮箱:1249802206@qq.com
地址:江苏省盐城市盐都区顺丰物流园2号楼403室
网址: www.chdrkj.com
Is the product installed correctly? The thickness of insulating cotton, the length of winding, inductance and input current required by each type of electromagnetic heater and electromagnetic heating coil are different. The manufacturers of large heating platforms must follow the installation instructions of Junkai Electrical Appliances when they leave the factory. And the coil spacing between each electromagnetic heating control panel is also very important, because too close to each other will affect each other. Only when the electromagnetic heater is installed in the normal parameter range can the long-term stable operation be guaranteed.
The degree of care for products. For the users with large dust and dust in the workshop, they should brush the fan on the electromagnetic heater regularly with a brush, and dust on the electromagnetic heating coil. For the coil, there is no need to press or cut the coil, and no water is often splashed on the coil or the electromagnetic induction heater. Don't expose the electromagnetic heater to the open air environment, because if the open air environment encounters rainy days, it must be wet, and when it is not dry, it will lead to damage. Or open-air environment in the morning more rain and dew, resulting in wet circuit boards, not dry power will also lead to short circuit inside the line.
Attention to dust prevention: After long-term use of electromagnetic heater, PCB and fan will produce a large amount of dust accumulation, which will have a great impact on the normal work and life of electromagnetic heating plate. Therefore, it is suggested that users should regularly use blowing tools to clean the dust on the electromagnetic heating plate and cooling fan to keep them clean, which is necessary for the stability of the electromagnetic heater.
Waterproof: Electromagnetic heaters belong to electrical products, so they are afraid of water, so it is necessary to maintain a dry air environment around the electromagnetic heater.
Attention to ventilation: When the electromagnetic heater runs, it will generate a lot of heat. Therefore, the electromagnetic heater should be installed in a ventilated and dry place, which is conducive to the radiation of the electromagnetic heater, so that the stability of the electromagnetic heater can be effectively guaranteed.
Attention to corrosion protection: If there is corrosive gas around the electromagnetic heater, special attention should be paid to it. Therefore, these corrosive air will affect the stability of the electromagnetic heater. Therefore, it is recommended that users spray the electromagnetic heater with insulating varnish or other insulating anticorrosive materials. The air temperature should not be higher than 50 C. At the same time, attention should be paid to the main engine of the electromagnetic heater. Inlet and outlet pipes and drip pipes will be blocked if not handled in time.
Zhang Tian:15895191047
Du Wenhua:13961983587
Xu Zhongyong:13962067633
mailbox:1249802206@qq.com
address:Shunfeng Logistics Park, Yandu District, Yancheng City, Jiangsu Province
Website: www.chdrkj.com
manager zhang | Alibaba |